Benjamin Removal Tool: A Step-by-Step Guide If you own a classic Benjamin or Sheridan multi-pump pneumatic air rifle
, performing your own maintenance is part of the ownership experience. Over time, these rifles can lose compression, leak air, or require new internal seals. To rebuild the rifle and swap out the seals, you cannot use standard workshop wrenches. Instead, you need a specialized Benjamin Valve Body Removal Tool Go to product viewer dialog for this item. (often cataloged as the Go to product viewer dialog for this item.
or SHET4 tool) to safely extract the internal valve nut without ruining the compression tube.
This step-by-step guide walks you through prepping your rifle, using the specialized removal tool, and extracting the valve assembly cleanly. 🛠️ Tools and Materials Required
Before starting, ensure your workspace is clean, well-lit, and organized. You will need: Benjamin/Sheridan Valve Removal Tool Go to product viewer dialog for this item. (features a square male spanner head) Flathead and Phillips head screwdrivers Small pin punch and a light hammer Replacement seal/valve kit
High-quality airgun oil (such as silicone-based oil; avoid petroleum lubricants) 🛑 Step 1: De-pressurize and Strip the Stock
Safety is your primary priority. Working on a pressurized airgun can result in severe injury or permanently damage the internal threads of the rifle.
Fire the rifle empty in a safe direction to confirm no residual air is trapped in the pressure chamber.
Use a flathead screwdriver to remove the stock screw located in front of the trigger guard.
Carefully lift the barrel and compression tube assembly out of the wooden stock and set the stock aside. 🔩 Step 2: Remove the Rear Receiver and Hammer
To reach the valve sitting deep inside the compression tube, you must clear the firing mechanisms out of the back of the receiver.
Locate and remove the pins or screws securing the retention cap at the very rear of the cylinder. Maintain pressure on the cap, as it sits directly against a loaded spring.
Slide out the rear guide pin, the hammer spring, and the hammer.
Peer down into the open rear of the compression tube. You will see a brass or steel locknut with a filleted square hole and a thin valve stem protruding through the center. 🔧 Step 3: Insert the Benjamin Removal Tool
Standard tools will strip this square nut immediately. The specialized removal tool is engineered to slide perfectly over the valve stem and lock directly into the square recess.
Leave a Reply